Model Planes

..

Micro-plastic seat belts designed for plastic scale aircrafts. Belts are made from micro-plastic foil and in combination with attached photo etched buckles they look highly realistic. This product is available in 1/48 scale.- microplastic sheeting, metallic buckles- it is possible to make seat belts..

iNSTRUCTiONS1. Clean model surface by wet cloth. Optional undercoat is Mr. Surfacer 1000 or Base White.2. Cut each design out of decal sheet and dip them in warm water (30 - 40C) for 10 - 15 seconds.3. Check with finger tip if design loose on base paper. if so place it in proper position on mo..

This spoke eyelets accessory set is suitable for WWI kits in 1/32 scale. The photo-etched sheet includes 160 pieces, that are designed in cooperation with Eduard company...

Complete pack of positive rivets for P-47D in 1/32 scale. Riveting sets from HGW Models give to surfaces of plastic kits highly realistic look. We recommend to apply them under the paint and when your model is painted just polish the surface to make the accessory visible. Suitable for Hasegawa kit...

Control surfaces from HGW Models for Messerschmitt Bf 109F/G/K aircraft model. It isn't ordinary decal but wet transfer which doesn't leave any signs of varnish or typical transparent film around the decal. This products is designed directly for kits by Hasegawa or Revell in 1/32 scale...

Complete pack of positive rivets for Focke-Wulf Fw 190D-9 in 1/32 scale. Riveting sets from HGW Models give to surfaces of plastic kit highly realistic look. HGW Models recommends to apply them under the paint and when your model is painted just polish the surface to make the accessory visible. Suit..

accessory suitable for Albatros D.V & Va by Wingnut Wings,photo etched parts developed in cooperation with Eduard company,1/32 scale..

#NOTE: The set does NOT include a model kit...

#NOTE: The set does NOT include a model kit...

3D PrintedF-105 (G,D) "Thunderchief" nose cone with pitot tube for Trumpeter kit..

..

Suitable forItaleri/Revell..

..

1/48 F-105 Thunderchief Air Intakes, Landing Gears with Wheels Bays, Weighted Wheels for Hobby Boss Kit (3D Printed)..

3D PrintedF-105 (G,D) "Thunderchief" nose cone with pitot tube for HobbyBoss kit..

..

..

..

..

3D Printed..

For Tamiya kitsSCALE 1/32 - Upgrade set..

For REVELL kitsSCALE 1/32 - Upgrade set..

..