Echelon Fine Details D356233 Decals for 1/35 Task Force Bandit & 11 ACR Humvee

Covering 2 specific units in this set: 3 COS serving in Iraq & 11 ACR during NTC training exercise. Although not illustrated in the instructions, the Bandit logo and tac markings were seen on other AFVs in the unit. Mainly M1117 ASV Guardian (no. 14) and M1078 FMTV armoured truck (no. 15).
11 ACR portion of the set, on the other hand, covered two vehicles: bomber codes HHT 445 & HHT 112. The unit's prominent logo (rearing horse with crossed schimitars) can be seen on other vehicles such as the VISMOD M113s.

Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.