Print Scale 72-150 1/72 Wet Decals - Convair F-102 Delta Dagger Part2 The Complete Set 1.5 Leaf (2 sheets)

Type: water-slide decals
1. Convaiir F-102A Delta Dagger 61144, serving with 95th FIS at Andrews AFB, Maryland, 1958. Overall Gloss Grey with black radome.
2. Convaiir F-102A Delta Dagger 61103, serving with 86th Fighter Interceptor Youngstown Municiple Airport, Ohio, 1957-1960. Overall Gloss Grey With black radome.
3. Convair F-102A Delta Dagger 61444, serving with 326th FIS at Richards-Gebaur AFB, Missouri, 1957-1958 Overall Gloss Grey with yellow wing fences.
4. Convair F-102A Delta Dagger 61009, serving with 48th FIS at Langley AFB, Virginia, 1959. Overall Gloss Grey with white tail. and red wing fences.
5. Convair F-102A Delta Dagger 53377,serving with 16th FIS at Naha AFB, Okinawa, 1959. Overall Gloss Grey With blue wing
fences.
6. Convair F-102A Delta Dagger 56-1444 PK, serving with 509th FIS Da Nang AFB, South Vietnam, 1968. overall 1-1-4 SEA scheme of Tan, Olive Drab and Dark Green with Flat Grey under surfaces.
7. Convair F-102A Delta Dagger 70892, serving with 82nd FIS at Travis AFB, Texas, 1964. Overall Gloss Grey with white radome.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.