1/32, 1/48, 1/72 USN A-6E Intruders on the Big Screen: Devil 501 and Devil 505

Note: This set does NOT include aircraft kit.

In late 1989, A-6E TRAM Intruders from VA-165 Boomers were modified to represent the earlier A-6A from VA-196 Main Battery during a fictitious 1972 USS Independence Vietnam War cruise.

This small special sheet includes decals for three scales - 1/32, 1/48,and 1/72 - and includes the exterior markings to reproduce Devil 501 or 505 in each of the three scales. Decals for crew helmets for both aircraft and one external fuel tank are also provided.

NOTE - The national insignias are intentionally mis-proportioned on the decal sheet, this is how they appeared on the actual 501 and 505. The insignias were not applied according to correct dimensions/specifications.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.