Model Planes
Brand: Eduard
SKU: ED BIG7261
This Big ED set includes:CX252 Su-27 Flanker A 1/7272503 Su-27 Flanker A exterior72510 Su-27 ladder73350 Su-27 Flanker A S.A...
US$36.37
31 % OFF
US$24.79
Brand: Techmod
SKU: TD 48087
Type: water-slide decals
Scale: 1/48
Decals Manufacturer: TECHMOD
Sheet Size: 180x130mm
Potez 63-11 c/n 7..
US$10.37
44 % OFF
US$5.77
Pre-Order
Brand: Inside the Armour
SKU: ITAD4801
From 1967 to 1970, the 13th TFS ("The Panther Pack") served as a fighter element in the 432nd Tactical Reconnaisane Wing at Udorn RTAFB, Flying missions to intercept North Vietnamese supply lines, including bombing, and escorting AC-130 Gunships.This set includes markings for four of the more colo..
US$10.61
Brand: Techmod
SKU: TD 32032
Type: water-slide decals
Scale: 1/32
Decals Manufacturer: TECHMOD
Sheet Size: 260x180mm
Stripes for Lozen..
US$10.37
44 % OFF
US$5.77
Brand: Techmod
SKU: TD 32030
Type: water-slide decals
Scale: 1/32
Decals Manufacturer: TECHMOD
Sheet Size: 260x180mm
Two colour varian..
US$19.47
39 % OFF
US$11.79
Brand: Eduard
SKU: ED 49424
Type: colour zoom self-adhesive photo-etched parts..
US$18.17
35 % OFF
US$11.79
Brand: Resin Improvement
SKU: RESIM-CM72030
Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by tracing all ..
US$4.52
48 % OFF
US$2.34
Pre-Order
Pre-Order
Pre-Order
Pre-Order
Pre-Order
Brand: Quinta Studio
SKU: Q-QD72203
3D Decals Instructions
- Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model.
- For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface.
- Avoid leaving the decal in water for too long, as this may ca..
US$10.37
20 % OFF
US$8.24
Pre-Order
Pre-Order
Pre-Order
Brand: Quinta Studio
SKU: Q-QD72189
3D Decals Instructions
- Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model.
- For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface.
- Avoid leaving the decal in water for too long, as this may ca..
US$5.17
25 % OFF
US$3.84
