Print Scale 48-142 Decals for 1/48 Hawker Sea Fury Part.2

1. Hawker Sea Fury FB.11 UB-471 of Burma Air Force, January 1959. Aluminium lacquer scheme overall (not natural metal), with Red spinner and white and red chequered rudder. Note lack of arresting hook.
2. Hawker Sea Fury FB.11 FAR42 of Cuban 'Fuerza Aerea Revolucionaria' (Revolutionary Air Force), probably 1963. Dark Green scheme overall with yellow stencilled serial number on rudder. Note lack of arresting hook. Aircraft depicted with eight rocket proyectiles with HE heads and two auxiliary fuel tanks, probably aluminium lacquer colour.
3. Hawker Sea Fury FB.60 321 of Iraqi Air Force, based at Basra in 1956. Camouflage scheme consisted of Dark Earth and Mid Stone over Azure Blue undersides, with white bands on fuselage and wings. Note Azure Blue spinner and lack of arresting hook.
4. Hawker Sea Fury FB.50 27:6 of 860 Squadron, Royal Netherlands Navy, 1952. Standard Pattern 2 camouflage scheme of Extra Dark Sea Grey over Sky. Note Extra Dark Sea Grey spinner and arresting hook. Aircraft depicted with two auxiliary fuel tanks.

Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.