Model Planes

..

1/48 Rafale (C, M) female pilot sitting in ejection seat for HobbyBoss kit (1pc)..

Rafale (C, M) male pilot sitting in ejection seat for Revell/Academy kit (1 pcs) (3D Printed) (1/48)..

..

..

..

A set of 4 x 1/48 RAF bomb carriers with outstanding detail3D printed, these items arrive attached to their supports for safety, and will need some clean up after separation from the supports...

A set of 4 x 1/48 RAF light bomb carriers with outstanding detailSuitable for interwar and WWII airfcraft3D printed, these items arrive attached to their supports for safety, and will need some clean up after separation from the supports...

A set of 12 x 1/48 RAF 20lb Bombs with outstanding detail Suitable for WW1 and early WWII airfcraft3D printed, these items arrive attached to their supports for safety, and will need some clean up after separation from the supports...

..

..

Pivot pylons for FB-111 (4 pcs) (3D Printed) (1/48)..

Pivot pylons for F-111F with LAU-105 (4 pcs) (3D Printed) (1/48)..

Pivot pylons for F-111C with LAU-105 (4 pcs) (3D Printed) (1/48)..

Pivot pylons for F-111 (A, D, E) with LAU-105 (4 pcs) (3D Printed) (1/48)..

1/48 Pilot seats for CH-53E Super Stallion and MH-53E Sea Dragon for Academy kit (2pcs..

a fully detailed multi-part 3D printed Perseus engine kit for the Airfix Lysander. to assist in converting it to a MkIIHugely improves kit detail and allows numerous display optionsincluding: - individual super detailed cylinders - accurate and highly refined cylinder baffles- new exhaust rin..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

..

..