Military Vehicles & Tanks

Fahrpanzer Gruson shells3d printed parts..

Fahrpanzer exterior set.- hollow chains-Gruson factory label x2-Stopping brackets3d printed parts..

3d printed parts..

3d printed parts..

Fahrpanzer ammunition box-8 fully loaded racks-1 empty rack-1 open semi-full shells rack3d printed parts..

..

#NOTE: The set does NOT include a model kit...

#NOTE: The set does NOT include a model kit...

A set of old type electrical boxes. In addition to the boxes, the set includes a decal and a 30cm long wire. Each box is separate, which allows you to create an electrical station in any configuration...

Ehrhardt stockwinde (jack). 2 per set.It may be Ehrhardt was equipped with 2 stockwinde, there are almost no images showing the same car from both sides, only one series showing Ehrhardts in Italy. Also "Griep-to" had at least one stockwinde installed at the back of the car...

Photo etched set for Ehrhardt 1917 Armoured Car..

Grousers for Ehrhardt3d printed parts..

Dismantled grouser rims for Ehrhardt kit number 350103d printed parts..

Early type rear fenders for 35010 Ehrhardt armoured car3d printed partsSome of the Ehrhardts had only this version installed, next batch had different style fenders, the one included with the plastic kit..

An MG08 with cradle (one MG in the set) mount for 35010 Ehrhardt armoured car.3d printed parts..

Ehrhardt louvers for 35010 Ehrhardt armoured car3d printed parts..

Additional tanks for Ehrhardt - 35010 Ehrhardt armoured car.3d printed partsEhrhardts from the 2nd platoon were equipped with these tanks, it is not known if those were additional fuel tanks or water tanks. Later, we found that tanks were installed on both sides of the car...

Products made in 3D are not assembled or painted, and there may be colour differences depending on the resin.Experience in removing 3D parts is useful but not essential. Any supports connected to the detail can be cut with side cutters or a slitting disc; the remainder can be broken off with snip..

Products made in 3D are not assembled or painted, and there may be colour differences depending on the resin.Experience in removing 3D parts is useful but not essential. Any supports connected to the detail can be cut with side cutters or a slitting disc; the remainder can be broken off with snip..