Scenics & Diorama

..

..

..

..

Tips for using 3D-print parts 1. Some 3D-print parts may have slight layer patterns or pixel patterns. Please spray primer before using. 2. If the part is bent and deformed, please use hot water or a hair dryer to heat it and correct it. 3. If there is residual resin or debris on the surface of the ..

..

..

..

..

..

Made by direct 3D printing...

To quickly build temporary runways, US engineering services built various options for the airfield. Aerodrome steel plates were M8A1 used in the Vietnam War in the second half of the 1960s and early 1970s and were installed by engineering units of the US Army. Plates were connected to each other eit..

Dimensions: 40cm x 30cm..

M8A1 US Landing Mat (210x336 mm)The M8A1 steel plates, developed by the US Army Corps of Engineers, were primarily used for the quick construction of temporary runways. These plates were extensively used during the Vietnam War in the late 1960s and early 1970s, particularly in army aviation for ba..

..

A plastic model of a bomb truck used on Allied airfields during World War II and well into the 1960s. The kit contains parts for four carts, decals and a sheet of photo-etching...

The US Norden sight was installed in all American bombers during World War II. war. The kit contains three resin parts...

..

..

The set contains three types of fire extinguishers for US vehicles from WWII, a total of twelve pieces with decals. Made using 3D printing technology...

Contains photoetched sheet and wooden parts...

The set consists of open and closed kettles. All printed using precision 3D printing...

The set contains two types of fire extinguishers for british vehicles from WWII, a total of ten pieces with decals. Made using 3D printing technology...

..