All Products

The item that Royal Model offers is manufactured in high quality polyurethane resin. The use of this material has enabled us to achieve high levels of detail without compromising the quality of the product. RM believes that this product, the result of careful historical and anatomical research, alth..

German 7.92 Metall ammunition belts (All kits) WWII3D decals 1. Soak the decal in the warm water for a couple of seconds and after its separation from the backing paper position it on the model. 2. To increase the decal's adherence use the white glue, Mr. Mark Setter or apply it to the glossy surfac..

..

..

The kit contain unassembled resin parts...

..

Item produced in resin...

(Type: model figures) This is a resin model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

..

..

It is an upgrade for Tamiya M3 halftracks, including the Drive Wheel and rear wheel. This is an upgrade version of the old set with 2 extra parts and a new Drive Wheel...

..

..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

..

..

..

(Type: model figures) The item that Royal Model offer is produced in polyurethane resin of the highest quality. The use of this material has enabled us to achieve high levels of detail without compromising the quality of the product. They are sure that this accessory item will give that extra specia..

Item produced in resin and photo-etched metal...

..

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

Please note: Tank is not included.170 links in 1/35th scale and a wire to obtain the track pivots...